This is the full kit of 2016 and newer Tacoma cover-lay applique's.
10 piece set. Cover-Lay appique's to cover your existing chrome badges, and fill in the letters indents on the tailgate.
1 toyota sombrero badge coverlay
2 "Tacoma" badge coverlays for both doors
2 "Limited" badge coverlays (if you dont have a limited edition, do not use, discard).
2 "SR5" badge coverlays ( if you do not have an SR5, do not use, discard).
1 "4x4" badge coverlay for tailgate. ( if you do not have a 4x4, do not use, discard).
1 "V6" badge coverlay for tailgate. (if you do not have a V6, do not use, discard).
1 set of " T A C O M A " tailgate inserts.
SORRY, THIS IS NOT "PARTED OUT", FULL KITS ONLY.
Install Driver & Passenger Side SR5 Emblem Applique.
a) Position part over factory emblem to check for proper fit prior to installation.
b) Remove adhesive liner by holding the Applique edges and pulling the adhesive liner pull tabs. Do not touch adhesive during installation.
c) Position Applique over factory emblem starting from the top edge then downward, ensuring it is centered. Applique should be flush to edge of factory surface +/- 2.0mm
d) Once positioned correctly, press firmly on Applique starting from the top edge then downward to fully adhere.
e) Follow with 2” rubber roller or soft felt block to ensure maximum adhesion contact.